Ecolink WST-232 Wireless Home Security Door Window Sensor White 5800 Wireless and 5GIG Compatible

$57.99

Added to wishlistRemoved from wishlist 0


Price: $57.99
(as of Jan 27, 2024 12:18:53 UTC – Details)



Enrolling

To enroll the sensor, set your panel into program mode, refer to your specific alarm panel manual for details on these menus.
When prompted by the panel:
* Touch the magnet to the side of the sensor that has three white lines. This will send a signal to the control panel as loop 2. Repeat as required.
* Connect the provided external wire, and short the wires together. This will send a signal to the control panel as loop 1. Repeat as required.
Mounting
Included with the contact is double sided tape for the contact and the magnet. For reliable bonding ensure the surface is clean and dry. Apply the tape to the sensor and then to the desired location. Apply firm pressure for several seconds. It is not recommended to mount the tape at temperatures below 50°F, although after 24 hours the bond will hold at low temperatures. One side of the sensor is marked with 3 lines; this indicates the location of the reed switch. The magnet should be mounted facing this side of the sensor, and it must be no further than 5/8 of an inch from the sensor.
In addition a mounting back plate with screws is provided. Simply screw the back plate onto the mounting surface and snap the sensor onto the mounting plate. To remove the sensor from the mounting plate, first remove the cover. At the bottom of the sensor (closest to the battery) a small tab will be visible. Use a small flat head screwdriver to press the plastic tab towards the wall, then slide the sensor up.

Note: Do not use the tape to secure the mounting plate to the wall.
Interchangeable Cover Feature
The contact comes from the factory assembled with a white cover, but included is an optional brown cover. To change the cover, slide the front cover to disengage it from the sensor then remove. Replace with the desired cover ensuring the Top (as marked on the inside of the cover)
Part Number: WST-232
Easy installs with included flush mount bracket and begins to learn as soon as batteries power it up.
Five year battery life and discrete design keep it out of sight and out of mind when not on alert.
External contact input available – 345 Mhz
Home/Garage Wireless Door/Window Tilt Security Sensor
Mounts with double sided tape or screw in mounting bracket
Interchangeable brown case (included)
Uses common CR2032 (3 V Lithium battery)
The Ecolink Wireless door/window sensor is designed with sophistication and compatible with 2GIG 345 Mhz Receivers.
Operating Temp: 32°-120°F (0°-49°C) Operating Humidity: 5-95% RH non-condensing

User Reviews

0.0 out of 5
0
0
0
0
0
Write a review

There are no reviews yet.

Be the first to review “Ecolink WST-232 Wireless Home Security Door Window Sensor White 5800 Wireless and 5GIG Compatible”

Your email address will not be published. Required fields are marked *

Ecolink WST-232 Wireless Home Security Door Window Sensor White 5800 Wireless and 5GIG Compatible
Ecolink WST-232 Wireless Home Security Door Window Sensor White 5800 Wireless and 5GIG Compatible

$57.99

Fastbuyelectronics.com
Logo
Shopping cart